25.10.2018
99
This chapter covers the following official Network+ objectives: Given a scenario, implement the appropriate wireless technologies and configurations. Given a scenario, troubleshoot common wireless connectivity and performance issues. This chapter covers CompTIA Network+ objectives 1.6 and 5.4.
For more information on the official Network+ exam topics, see the “About the Network+ Exam” section in the Introduction. One of the bigger changes in the networking world since the Network+ exam first came into being is in. With Safari, you learn the way you learn best. Get unlimited access to videos, live online training, learning paths, books, interactive tutorials, and more.
Don't rely on this vce. Pass my exam. I only saw 5 questions from this.
Alot of new questions. Its a hard one. I've got 3 sims. 1 with assign ip for HR/IT/etc. Which tools has created this result.
Official practice questions for A+, Security+, IT Fundamentals, and Network+ certifications from CompTIA. Fill out a quick form to test your knowledge today!
Crimp/Multimeter/Tone probe/ etc. Enable or disable. Here what I remember:-) 1. In OSPF which value will you choose: A: 0 B: 1 C: 110 D: 255 2. Qos unified communication A: use algorithm to conserve bandwidth B: Real time with unified communication with endpoints C: Prevent degration voice/video D: Only voice E: Video 3. You use OTDR reading.
Suddenly there is a drop 155 meters away. What cause this drop? A: Short B: Rx/Tx reversed C: Open D: Bend 4.
Bosch kts 670. You have 1 distribution switch and 5 access switch. How will you place them? A: In closet all units B: 1 distribution in MDF and 5 in IDF C: 5 access switch in MDF and 1 in distribution IDF D: All in IDF F: All in MDF 5. You are setting up EAP-TLS VPN concentrator.
Which authentication will provide back-end service? A: RADIUS B: Kerberos C: 802.1x D: IPSEC Good luck everyone! Just to update and maybe provide a bit of help to you guys out there who are looking to take the exam, I took it today and passed () and can confirm that this dump is still valid even though there are some new questions added that I hadn't come across. I got 4 sims. One was a drag and drop that required me to make a T568B cable. Second was a 3-4 switch scenario with lots of workstations connected to each switch and I had to either click each connect to either be red or green depending on which one ws causing problems (seemed like a switching loop). Third was the subnetting sim that's already pictured on this dump.
Last was also in this dump where I had to determine why the cable results were coming up as they were and had to select an explanation. Around 20 questions and 2 sims were from this dump. I got a question about something related to FCoE which I wasn't sure of as didn't realise what the acronym was.
The exam is full of acronyms!! Another question I remember was related to the what the correct state of an STP redundant interface is.
Hope that helps those of you who are looking to take this one. I found it tougher than my Cisco CCNP exams and only passed first time due to my strong experience and understanding in networking. There were 83 questions in total on the exam. I managed to get through the whole exam with around 15 mins to spare which I used to go over the questions I wasn't sure of.